Stop. If three cycles produce no improvement at all, the cause is not blockage. Check the symptoms on our guide to when a sound tool will not help, and have the device inspected rather than continuing to run cycles.
Tap the button below. It plays a low‑frequency sound that vibrates the speaker and pushes trapped water and dust out of the grille. Turn your volume up to about 80%.
💡 Point the speaker downward so gravity helps the water escape. Repeat 2–3 times if needed.
Select your issue and run the appropriate fix cycle to restore your speaker audio in about a minute.
Dry the outside of your phone first.
Let gravity help pull the water out.
Ensure audio plays through the phone's internal speakers.
Never use earbuds. Turn volume up, but 100% isn't required.
Our tool is designed to target the three most common speaker issues using precise acoustic frequencies. Whether your phone took a dive or just sounds muffled from pocket lint, here is how we fix it.
Clear trapped water from your phone in about 60 seconds. The steady 165 Hz vibration physically pushes trapped liquid out of the speaker mesh.
A steady 165 Hz tone — the sweet spot for maximum diaphragm travel — physically pushes trapped water out.
Use our deep clean mode to act as a dust remover. Sweeping low frequencies shake loose stubborn dirt, sand, and lint.
Sweeps across low frequencies (120–400 Hz) to shake loose lint, dust and stubborn droplets the single tone misses.
Act as a volume booster for muffled speakers. Clear out blockages to restore heavy sound, loud bass, and crisp audio.
A clean 440 Hz reference tone so you can hear whether your speaker sounds clear again after cleaning.
Perfectly safe. These are ordinary frequencies your speaker already plays during music. The tool never exceeds normal listening levels — it just concentrates the energy at the frequency range where diaphragm travel is greatest.
A fair review needs to cover where a method fails as well as where it succeeds. Here is both.
For a complete overview, see the complete diagnostic list.
Water removal. This is the strong case, and it is genuinely effective. Water is held by surface tension, which has a breaking threshold — enough diaphragm displacement exceeds it and the film fragments all at once. Often clears in a single cycle. Free, fast, and no risk at moderate volume. Apple uses the same principle on Apple Watch.
Dust and lint. Loose particulate comes out well; interlocked fibre comes out gradually across four or five passes; some does not come out at all. Combining cycles with exterior brushing and adhesive putty closes most of the gap. Expect substantial improvement rather than complete restoration on a months-old blockage.
Adhesive contamination. Oil, earwax, dried sugar. Held by adhesion rather than resting mechanically, and mechanical force does not break adhesive bonds at any amplitude.
Hardware faults. Torn diaphragms, corroded contacts, failed amplifiers, disconnected cables. Sound moves obstructions; it does not restore components.
Genuinely useful within a narrow scope, and worth trying first because it costs nothing and carries no risk on an intact speaker. The honest limitation is that it addresses two problems out of the several that make a speaker sound wrong — which is why identifying your symptom first matters more than the tool you use.
Stop. If three cycles produce no improvement at all, the cause is not blockage. Check the symptoms on our guide to when a sound tool will not help, and have the device inspected rather than continuing to run cycles.
No. The frequencies used sit inside the range your speaker already reproduces whenever you play music, and the tool runs at moderate volume rather than maximum. The one genuine caution is earbuds: never run ejection tones into in-ear devices while you are wearing them.
Thirty to sixty seconds per cycle, repeated two or three times with short pauses. Running it continuously for many minutes adds nothing once the accessible liquid is out, and only heats the voice coil.
No. Around 70 to 80 percent is the practical sweet spot. Maximum volume on a restricted diaphragm produces distortion rather than more displacement, and adds avoidable stress to the driver.
No. Rice is a poor desiccant — open moving air dries a device faster — and its starch dust migrates into the charging port, microphone holes and speaker grille, which can create a second problem on top of the first.
Our tool is great for water and dust, but it cannot fix physically blown speakers or electrical damage.
Learn when it won't workStep-by-step help for wet, muffled, crackling or quiet phone speakers.