If our tool doesn't fix the sound, your speaker might be blown. Read our guide on physical repairs and replacement costs.
💡 Point the speaker downward so gravity helps the water escape. Repeat 2–3 times if needed.
Water trapped in a speaker grille muffles the sound and can cause distortion. A strong, low‑frequency tone makes the speaker's diaphragm move a large distance back and forth — that mechanical vibration flicks droplets out of the mesh.
A steady 165 Hz tone — the sweet spot for maximum diaphragm travel — physically pushes trapped water out.
Sweeps across low frequencies (120–400 Hz) to shake loose lint, dust and stubborn droplets the single tone misses.
A clean 440 Hz reference tone so you can hear whether your speaker sounds clear again after cleaning.
Perfectly safe. These are ordinary frequencies your speaker already plays during music. The tool never exceeds normal listening levels — it just concentrates the energy at the frequency that moves water best.
Set your device to around 70–80% volume. The tool works by vibration, so it needs some power behind it.
Hold your phone with the speaker facing the floor or a soft cloth so water drains out instead of pooling deeper.
Press start and let the full cycle play. You may see or feel tiny droplets leave the grille.
Run it 2–3 times, then switch to “Test Sound” to confirm the audio is crisp again.
If cleaning has not worked and the speaker is genuinely faulty, the decision becomes financial rather than technical. These are the factors that actually determine the cost, and the questions worth asking before agreeing to anything.
Four things, roughly in order of impact:
A reasonable rule of thumb: when a quoted repair approaches half the device's current resale value, replacement usually makes more sense. Age matters too — spending significantly on a phone that will need a battery within a year is rarely good value. And if liquid reached the board, be aware that a successful repair today does not rule out corrosion-related failures in the months afterwards.
Back up your data first. A device that powers on today may not after disassembly, and liquid-damaged boards are unpredictable. This is the step people skip and regret.
If you have not already ruled out blockage and software settings, do that before paying anyone. Those two account for a large share of speaker complaints and cost nothing to eliminate. Work through the diagnostic list first.
Yes — for water trapped in the external speaker grille, the low‑frequency vibration is very effective. It cannot remove water from deep inside the device; if your phone was fully submerged, also power it off and let it air‑dry in a bag of rice or silica gel.
Completely. It plays standard audio frequencies at normal volume. It does not overdrive or damage the speaker. Just avoid setting the volume to 100% for long periods on cheap speakers, as with any loud audio.
Yes. It works on any device playing audio through this browser — phones, tablets, laptops and connected Bluetooth or wireless speakers.
Browsers only allow sound to start after you interact with the page. That single tap unlocks audio — after that the tool runs automatically.
No install and no account. Once the page has loaded it runs entirely on your device using your browser's built‑in audio engine.
The standard eject cycle takes about 15 to 60 seconds. We recommend running it 2-3 times for the best results.
Yes! It uses proven acoustic physics (specifically 165Hz tones) to physically push water and dust out of the speaker mesh.
This tool fixes muffled sound from water or dust. If your speaker is physically blown or crackling permanently, it will require hardware replacement at a repair shop.
Step-by-step help for wet, muffled, crackling or quiet phone speakers.