FREE · NO APP · WORKS IN YOUR BROWSER

Working out which speaker you actually have a problem with

Tap the button below. It plays a low‑frequency sound that vibrates the speaker and pushes trapped water and dust out of the grille. Turn your volume up to about 80%.

Frequency 165 Hz Time left 0.0 s

💡 Point the speaker downward so gravity helps the water escape. Repeat 2–3 times if needed.

🔧

Speaker Fix Tool

Select your issue and run the appropriate fix cycle to restore your speaker audio in about a minute.

Preparation

Before you start

🧻

Wipe visible water

Dry the outside of your phone first.

🔽

Speaker facing down

Let gravity help pull the water out.

🎧

Disconnect Bluetooth

Ensure audio plays through the phone's internal speakers.

🔊

Volume around 70-80%

Never use earbuds. Turn volume up, but 100% isn't required.

Core Features

Fix My Speaker Functions

Our tool is designed to target the three most common speaker issues using precise acoustic frequencies. Whether your phone took a dive or just sounds muffled from pocket lint, here is how we fix it.

Hover over the cards below to see the effect
💧

Eject Water

Clear trapped water from your phone in about 60 seconds. The steady 165 Hz vibration physically pushes trapped liquid out of the speaker mesh.

Eject Water

A steady 165 Hz tone — the sweet spot for maximum diaphragm travel — physically pushes trapped water out.

🧹

Clean Dust

Use our deep clean mode to act as a dust remover. Sweeping low frequencies shake loose stubborn dirt, sand, and lint.

Deep Clean

Sweeps across low frequencies (120–400 Hz) to shake loose lint, dust and stubborn droplets the single tone misses.

🎵

Restore Volume

Act as a volume booster for muffled speakers. Clear out blockages to restore heavy sound, loud bass, and crisp audio.

Test Sound

A clean 440 Hz reference tone so you can hear whether your speaker sounds clear again after cleaning.

Perfectly safe. These are ordinary frequencies your speaker already plays during music. The tool never exceeds normal listening levels — it just concentrates the energy at the frequency range where diaphragm travel is greatest.

Before fixing anything, it is worth establishing which component is affected. Most phones have two audio outputs that fail independently.

For a complete overview, see our step-by-step water removal guide.

The two outputs

The loudspeaker sits at the bottom edge and handles music, video, ringtones and speakerphone. The earpiece is the narrow slot above the screen, used for calls held to your ear — and on most modern phones it also serves as the second stereo channel.

The thirty-second test

Make a call held to your ear, then play a music file on speaker. If calls are clear but media is muffled, the bottom grille is blocked. If the reverse, the earpiece is. If both are equally dull, suspect a setting rather than debris — a physical obstruction cannot affect a driver it is not touching.

Watch for the decorative grille

Many phones have symmetrical openings either side of the charging port, but only one contains a driver — the other houses a microphone. Cover each with a fingertip while audio plays; if the sound does not change, that side was never a speaker.

They clog differently

The bottom speaker collects dry pocket lint, which is loose and responds well to acoustic cycles. The earpiece collects facial oil, sweat and cosmetics — sticky, adhesive residue that vibration cannot shift. That one needs adhesive putty and a soft brush instead.

What your symptom points to

FAQ

Common questions

Can this damage my speaker?

No. The frequencies used sit inside the range your speaker already reproduces whenever you play music, and the tool runs at moderate volume rather than maximum. The one genuine caution is earbuds: never run ejection tones into in-ear devices while you are wearing them.

How long should I run it?

Thirty to sixty seconds per cycle, repeated two or three times with short pauses. Running it continuously for many minutes adds nothing once the accessible liquid is out, and only heats the voice coil.

Should I set volume to maximum?

No. Around 70 to 80 percent is the practical sweet spot. Maximum volume on a restricted diaphragm produces distortion rather than more displacement, and adds avoidable stress to the driver.

Does the rice trick work?

No. Rice is a poor desiccant — open moving air dries a device faster — and its starch dust migrates into the charging port, microphone holes and speaker grille, which can create a second problem on top of the first.

It is still muffled after several tries. Now what?

Stop. If three cycles produce no improvement at all, the cause is not blockage. Check the symptoms on our guide to when a sound tool will not help, and have the device inspected rather than continuing to run cycles.

What this cannot fix

Our tool is great for water and dust, but it cannot fix physically blown speakers or electrical damage.

Learn when it won't work
HOVER TO BREAK HARDWARE DAMAGE

Speaker fix guides

Step-by-step help for wet, muffled, crackling or quiet phone speakers.

Specific Fixes & Tools