Thirty to sixty seconds per cycle, repeated two or three times with short pauses. Running it continuously for many minutes adds nothing once the accessible liquid is out, and only heats the voice coil.
Tap the button below. It plays a low‑frequency sound that vibrates the speaker and pushes trapped water and dust out of the grille. Turn your volume up to about 80%.
💡 Point the speaker downward so gravity helps the water escape. Repeat 2–3 times if needed.
Select your issue and run the appropriate fix cycle to restore your speaker audio in about a minute.
Dry the outside of your phone first.
Let gravity help pull the water out.
Ensure audio plays through the phone's internal speakers.
Never use earbuds. Turn volume up, but 100% isn't required.
Our tool is designed to target the three most common speaker issues using precise acoustic frequencies. Whether your phone took a dive or just sounds muffled from pocket lint, here is how we fix it.
Clear trapped water from your phone in about 60 seconds. The steady 165 Hz vibration physically pushes trapped liquid out of the speaker mesh.
A steady 165 Hz tone — the sweet spot for maximum diaphragm travel — physically pushes trapped water out.
Use our deep clean mode to act as a dust remover. Sweeping low frequencies shake loose stubborn dirt, sand, and lint.
Sweeps across low frequencies (120–400 Hz) to shake loose lint, dust and stubborn droplets the single tone misses.
Act as a volume booster for muffled speakers. Clear out blockages to restore heavy sound, loud bass, and crisp audio.
A clean 440 Hz reference tone so you can hear whether your speaker sounds clear again after cleaning.
Perfectly safe. These are ordinary frequencies your speaker already plays during music. The tool never exceeds normal listening levels — it just concentrates the energy at the frequency that moves water best.
An ordered checklist. Working through it in sequence resolves most speaker complaints and prevents treating the wrong thing.
For a complete overview, see our full guide: Diagnosing what is actually wrong.
Make a call held to your ear, then play music on speaker. One affected and one fine means a physical obstruction in that grille. Both equally dull means a setting. And establish whether the sound is quiet or completely silent — blockage never produces silence.
Restart the device. Turn Bluetooth off entirely. Set any equaliser flat. Check for a volume limiter. Remove the case. On Android, safe mode isolates third-party apps holding the audio route. Two minutes, no cost, and it resolves a meaningful share of complaints.
Case off, exterior blotted dry, grille brushed with a soft dry brush for thirty seconds. Brushing first matters — acoustic cleaning pushes material outward, so a packed grille has nowhere to expel into.
Bluetooth off, volume 70–80 percent while playing, grille facing straight down at about 45 degrees. Run 30–60 seconds, stop, wipe or brush, repeat. Two or three cycles for water with a fixed tone; four or five for dust with a sweep.
Record a voice memo before starting and play it back after each stage at fixed volume. Use speech rather than music — consonants expose remaining muffling. Test each driver separately.
Three cycles with no audible change means the blockage is not the responsive kind. Buzzing that worsens with volume means a torn diaphragm — stop immediately, because cycles at volume enlarge tears.
No charging for 24 to 48 hours if liquid was involved, however good the speaker sounds.
Thirty to sixty seconds per cycle, repeated two or three times with short pauses. Running it continuously for many minutes adds nothing once the accessible liquid is out, and only heats the voice coil.
No. Around 70 to 80 percent is the practical sweet spot. Maximum volume on a restricted diaphragm produces distortion rather than more displacement, and adds avoidable stress to the driver.
No. Rice is a poor desiccant — open moving air dries a device faster — and its starch dust migrates into the charging port, microphone holes and speaker grille, which can create a second problem on top of the first.
Stop. If three cycles produce no improvement at all, the cause is not blockage. Check the symptoms on our guide to when a sound tool will not help, and have the device inspected rather than continuing to run cycles.
No. The frequencies used sit inside the range your speaker already reproduces whenever you play music, and the tool runs at moderate volume rather than maximum. The one genuine caution is earbuds: never run ejection tones into in-ear devices while you are wearing them.
Our tool is great for water and dust, but it cannot fix physically blown speakers or electrical damage.
Learn when it won't workStep-by-step help for wet, muffled, crackling or quiet phone speakers.