Stop. If three cycles produce no improvement at all, the cause is not blockage. Check the symptoms on our guide to when a sound tool will not help, and have the device inspected rather than continuing to run cycles.
Tap the button below. It plays a low‑frequency sound that vibrates the speaker and pushes trapped water and dust out of the grille. Turn your volume up to about 80%.
💡 Point the speaker downward so gravity helps the water escape. Repeat 2–3 times if needed.
Select your issue and run the appropriate fix cycle to restore your speaker audio in about a minute.
Dry the outside of your phone first.
Let gravity help pull the water out.
Ensure audio plays through the phone's internal speakers.
Never use earbuds. Turn volume up, but 100% isn't required.
Our tool is designed to target the three most common speaker issues using precise acoustic frequencies. Whether your phone took a dive or just sounds muffled from pocket lint, here is how we fix it.
Clear trapped water from your phone in about 60 seconds. The steady 165 Hz vibration physically pushes trapped liquid out of the speaker mesh.
A steady 165 Hz tone — the sweet spot for maximum diaphragm travel — physically pushes trapped water out.
Use our deep clean mode to act as a dust remover. Sweeping low frequencies shake loose stubborn dirt, sand, and lint.
Sweeps across low frequencies (120–400 Hz) to shake loose lint, dust and stubborn droplets the single tone misses.
Act as a volume booster for muffled speakers. Clear out blockages to restore heavy sound, loud bass, and crisp audio.
A clean 440 Hz reference tone so you can hear whether your speaker sounds clear again after cleaning.
Perfectly safe. These are ordinary frequencies your speaker already plays during music. The tool never exceeds normal listening levels — it just concentrates the energy at the frequency range where diaphragm travel is greatest.
Practical rather than theoretical. Most phone-specific failures come from three OS behaviours that are easy to work around once you know them.
For a complete overview, see clearing trapped water properly.
Phones connect to paired devices automatically and without notification. If earbuds are in a bag or a car system is within range, the tone plays there and nothing reaches your wet speaker. Turn Bluetooth off in settings, not via a quick toggle that only disconnects.
Media, ringer, calls and alarms have independent levels. Pressing the volume rocker before audio is playing usually adjusts the ringer. Start the tone, then adjust — that guarantees you are moving media volume.
Bass enhancement, dynamic compression and loudness normalisation all alter the waveform before it reaches the driver. Set any equaliser or sound-effect mode to flat first.
Case off. Blot the exterior with a soft cloth, pressing rather than rubbing. Grille facing straight down, phone tilted about 45 degrees so liquid runs off the casing rather than pooling beside the opening. Hold it away from your clothes.
30 to 60 seconds, then stop and blot the grille before the next cycle. Two or three cycles for water. The wipe between cycles matters — without it, the next intake stroke draws the same water back in.
Record a short voice memo before you start and play it back after each cycle at fixed volume. Comparing against an unchanging file is far more reliable than memory. Listen for consonants — soft or smeared s and t sounds mean something is still in the mesh.
No port charging for 24 to 48 hours. Wireless charging is safe if supported.
Stop. If three cycles produce no improvement at all, the cause is not blockage. Check the symptoms on our guide to when a sound tool will not help, and have the device inspected rather than continuing to run cycles.
No. The frequencies used sit inside the range your speaker already reproduces whenever you play music, and the tool runs at moderate volume rather than maximum. The one genuine caution is earbuds: never run ejection tones into in-ear devices while you are wearing them.
Thirty to sixty seconds per cycle, repeated two or three times with short pauses. Running it continuously for many minutes adds nothing once the accessible liquid is out, and only heats the voice coil.
No. Around 70 to 80 percent is the practical sweet spot. Maximum volume on a restricted diaphragm produces distortion rather than more displacement, and adds avoidable stress to the driver.
No. Rice is a poor desiccant — open moving air dries a device faster — and its starch dust migrates into the charging port, microphone holes and speaker grille, which can create a second problem on top of the first.
Our tool is great for water and dust, but it cannot fix physically blown speakers or electrical damage.
Learn when it won't workStep-by-step help for wet, muffled, crackling or quiet phone speakers.