Tap the button below. It plays a low‑frequency sound that vibrates the speaker and pushes trapped water and dust out of the grille. Turn your volume up to about 80%.
💡 Point the speaker downward so gravity helps the water escape. Repeat 2–3 times if needed.
Select how wet your device got, then tap Eject Water to run a customized cleaning cycle.
Dry the outside of your phone first.
Let gravity help pull the water out.
Ensure audio plays through the phone's internal speakers.
Never use earbuds. Turn volume up, but 100% isn't required.
Our tool is designed to target the three most common speaker issues using precise acoustic frequencies. Whether your phone took a dive or just sounds muffled from pocket lint, here is how we fix it.
Clear trapped water from your phone in about 60 seconds. The steady 165 Hz vibration physically pushes trapped liquid out of the speaker mesh.
A steady 165 Hz tone — the sweet spot for maximum diaphragm travel — physically pushes trapped water out.
Use our deep clean mode to act as a dust remover. Sweeping low frequencies shake loose stubborn dirt, sand, and lint.
Sweeps across low frequencies (120–400 Hz) to shake loose lint, dust and stubborn droplets the single tone misses.
Act as a volume booster for muffled speakers. Clear out blockages to restore heavy sound, loud bass, and crisp audio.
A clean 440 Hz reference tone so you can hear whether your speaker sounds clear again after cleaning.
Perfectly safe. These are ordinary frequencies your speaker already plays during music. The tool never exceeds normal listening levels — it just concentrates the energy at the frequency range where diaphragm travel is greatest.
The difference between a cycle that works and one that does not is mostly setup. The same tool, run two ways, produces noticeably different results.
For a complete overview, see the dust removal walkthrough.
Grille facing straight down, device angled roughly 45 degrees rather than held flat. Flat means expelled debris sits on the casing right next to the opening. Angled means it falls away. This is a small change that measurably affects how much stays out.
Run 30 to 45 seconds, then stop. Brush or blow gently across the grille exterior — not into it — to clear what has just been pushed out. Then run the next cycle. Four or five passes structured this way outperforms a single long run by a wide margin, because each pass starts with a clear exit path.
For dust specifically this matters. A steady frequency lets debris settle into a position within the oscillation where it stops being disturbed. A sweep continually changes the motion so no stable position exists. If your tool offers both, dust is the case for sweep.
Dust improves incrementally rather than suddenly. Listen for the tone itself becoming cleaner and slightly louder between cycles without you touching the volume — that is the obstruction reducing. Water tends to produce one clear step change; dust produces a gradient.
Five passes is a reasonable ceiling. Beyond that the returns are negligible and the voice coil has been working hard. If the sound has improved but not fully recovered, a second session the following day often gains a little more once settled debris has redistributed.
No. The frequencies used sit inside the range your speaker already reproduces whenever you play music, and the tool runs at moderate volume rather than maximum. The one genuine caution is earbuds: never run ejection tones into in-ear devices while you are wearing them.
Stop. If three cycles produce no improvement at all, the cause is not blockage. Check the symptoms on our guide to when a sound tool will not help, and have the device inspected rather than continuing to run cycles.
Yes. Water is held by surface tension and usually clears in one or two cycles. Dust is wedged mechanically and held by static, so it needs a sweeping range of frequencies and several more passes.
Thirty to sixty seconds per cycle, repeated two or three times with short pauses. Running it continuously for many minutes adds nothing once the accessible liquid is out, and only heats the voice coil.
For maintenance, roughly once a month is plenty. More often if you exercise heavily, work outdoors, or live somewhere humid or dusty. There is no benefit to daily use on a speaker that sounds fine.
Our tool is great for water and dust, but it cannot fix physically blown speakers or electrical damage.
Learn when it won't workStep-by-step help for wet, muffled, crackling or quiet phone speakers.