Tap the button below. It plays a low‑frequency sound that vibrates the speaker and pushes trapped water and dust out of the grille. Turn your volume up to about 80%.
💡 Point the speaker downward so gravity helps the water escape. Repeat 2–3 times if needed.
Select the type of debris clogging your speaker, then run a targeted deep clean cycle.
Dry the outside of your phone first.
Let gravity help pull the water out.
Ensure audio plays through the phone's internal speakers.
Never use earbuds. Turn volume up, but 100% isn't required.
Our tool is designed to target the three most common speaker issues using precise acoustic frequencies. Whether your phone took a dive or just sounds muffled from pocket lint, here is how we fix it.
Clear trapped water from your phone in about 60 seconds. The steady 165 Hz vibration physically pushes trapped liquid out of the speaker mesh.
A steady 165 Hz tone — the sweet spot for maximum diaphragm travel — physically pushes trapped water out.
Use our deep clean mode to act as a dust remover. Sweeping low frequencies shake loose stubborn dirt, sand, and lint.
Sweeps across low frequencies (120–400 Hz) to shake loose lint, dust and stubborn droplets the single tone misses.
Act as a volume booster for muffled speakers. Clear out blockages to restore heavy sound, loud bass, and crisp audio.
A clean 440 Hz reference tone so you can hear whether your speaker sounds clear again after cleaning.
Perfectly safe. These are ordinary frequencies your speaker already plays during music. The tool never exceeds normal listening levels — it just concentrates the energy at the frequency that moves water best.
Acoustic cleaning has a specific reach. Understanding exactly where that reach ends explains both why it helps and why it rarely produces a complete result on its own.
For a complete overview, see our full guide: Clean dust and lint from a speaker.
This is the key point and the one most guides omit. The diaphragm sits behind the mesh, so the airflow it generates pushes outward through the grille. Acoustic cleaning therefore acts on material sitting between the diaphragm and the outer openings — it pushes debris toward the exit rather than pulling it out.
If the outer openings are packed, expelled material has nowhere to go and settles straight back. Thirty seconds of brushing before the first cycle measurably increases how much stays out. Brushing again after the cycles removes what has just been pushed to the surface.
Nothing. Fibre held by oil, wax or dried mineral deposit is attached by adhesion rather than resting mechanically. Vibration applies mechanical force, which does not break adhesive bonds regardless of amplitude. Increasing volume only heats the coil.
On a typical months-old blockage, acoustic cycles combined with brushing usually recover most of the lost clarity. The remainder is generally bonded fibre or material past the mesh. Neither responds to any home method, and pursuing them with sharp tools or compressed air makes the situation permanently worse rather than better.
No. The frequencies used sit inside the range your speaker already reproduces whenever you play music, and the tool runs at moderate volume rather than maximum. The one genuine caution is earbuds: never run ejection tones into in-ear devices while you are wearing them.
Stop. If three cycles produce no improvement at all, the cause is not blockage. Check the symptoms on our guide to when a sound tool will not help, and have the device inspected rather than continuing to run cycles.
Yes. Water is held by surface tension and usually clears in one or two cycles. Dust is wedged mechanically and held by static, so it needs a sweeping range of frequencies and several more passes.
Thirty to sixty seconds per cycle, repeated two or three times with short pauses. Running it continuously for many minutes adds nothing once the accessible liquid is out, and only heats the voice coil.
For maintenance, roughly once a month is plenty. More often if you exercise heavily, work outdoors, or live somewhere humid or dusty. There is no benefit to daily use on a speaker that sounds fine.
Our tool is great for water and dust, but it cannot fix physically blown speakers or electrical damage.
Learn when it won't workStep-by-step help for wet, muffled, crackling or quiet phone speakers.