Stop. If three cycles produce no improvement at all, the cause is not blockage. Check the symptoms on our guide to when a sound tool will not help, and have the device inspected rather than continuing to run cycles.
Tap the button below. It plays a low‑frequency sound that vibrates the speaker and pushes trapped water and dust out of the grille. Turn your volume up to about 80%.
💡 Point the speaker downward so gravity helps the water escape. Repeat 2–3 times if needed.
Select your issue and run the appropriate fix cycle to restore your speaker audio in about a minute.
Dry the outside of your phone first.
Let gravity help pull the water out.
Ensure audio plays through the phone's internal speakers.
Never use earbuds. Turn volume up, but 100% isn't required.
Our tool is designed to target the three most common speaker issues using precise acoustic frequencies. Whether your phone took a dive or just sounds muffled from pocket lint, here is how we fix it.
Clear trapped water from your phone in about 60 seconds. The steady 165 Hz vibration physically pushes trapped liquid out of the speaker mesh.
A steady 165 Hz tone — the sweet spot for maximum diaphragm travel — physically pushes trapped water out.
Use our deep clean mode to act as a dust remover. Sweeping low frequencies shake loose stubborn dirt, sand, and lint.
Sweeps across low frequencies (120–400 Hz) to shake loose lint, dust and stubborn droplets the single tone misses.
Act as a volume booster for muffled speakers. Clear out blockages to restore heavy sound, loud bass, and crisp audio.
A clean 440 Hz reference tone so you can hear whether your speaker sounds clear again after cleaning.
Perfectly safe. These are ordinary frequencies your speaker already plays during music. The tool never exceeds normal listening levels — it just concentrates the energy at the frequency range where diaphragm travel is greatest.
Five things to disable before a cycle. Each one interferes in a different way, and the first is the single commonest reason people conclude the tool does not work.
For a complete overview, see clearing trapped water properly.
The quick toggle on most phones disconnects current devices but leaves the radio active, and the phone will happily reconnect mid-cycle. Turn it off in settings. A paired device in range — earbuds in a bag, a car system, a smartwatch — takes the audio silently, and the tone never reaches your wet speaker.
Bass boost, virtual surround, loudness normalisation and Dolby processing all alter the waveform before it reaches the driver. The cleaning mechanism depends on a clean sine wave moving the diaphragm smoothly. Set everything flat.
Including scheduled ones that activate automatically at certain times — those catch people out because the behaviour appears and disappears on a timetable that seems random.
Regional media caps, accessibility volume limits, parental controls and screen-time restrictions can all cap output well below what you think you have set.
If the device has been wet, unplug it and leave it unplugged for 24 to 48 hours. Voltage across damp connector pins is the most common cause of permanent damage after liquid exposure. Wireless charging is safe if supported.
The case. Covers overlap grilles more often than people notice, and they trap expelled water and debris against the opening.
Volume 70–80 percent while audio is playing, grille facing straight down at about 45 degrees, dry cloth to hand for wiping between cycles.
Stop. If three cycles produce no improvement at all, the cause is not blockage. Check the symptoms on our guide to when a sound tool will not help, and have the device inspected rather than continuing to run cycles.
No. The frequencies used sit inside the range your speaker already reproduces whenever you play music, and the tool runs at moderate volume rather than maximum. The one genuine caution is earbuds: never run ejection tones into in-ear devices while you are wearing them.
Thirty to sixty seconds per cycle, repeated two or three times with short pauses. Running it continuously for many minutes adds nothing once the accessible liquid is out, and only heats the voice coil.
No. Around 70 to 80 percent is the practical sweet spot. Maximum volume on a restricted diaphragm produces distortion rather than more displacement, and adds avoidable stress to the driver.
No. Rice is a poor desiccant — open moving air dries a device faster — and its starch dust migrates into the charging port, microphone holes and speaker grille, which can create a second problem on top of the first.
Our tool is great for water and dust, but it cannot fix physically blown speakers or electrical damage.
Learn when it won't workStep-by-step help for wet, muffled, crackling or quiet phone speakers.