Stop. If three cycles produce no improvement at all, the cause is not blockage. Check the symptoms on our guide to when a sound tool will not help, and have the device inspected rather than continuing to run cycles.
Tap the button below. It plays a low‑frequency sound that vibrates the speaker and pushes trapped water and dust out of the grille. Turn your volume up to about 80%.
💡 Point the speaker downward so gravity helps the water escape. Repeat 2–3 times if needed.
Select your issue and run the appropriate fix cycle to restore your speaker audio in about a minute.
Dry the outside of your phone first.
Let gravity help pull the water out.
Ensure audio plays through the phone's internal speakers.
Never use earbuds. Turn volume up, but 100% isn't required.
Our tool is designed to target the three most common speaker issues using precise acoustic frequencies. Whether your phone took a dive or just sounds muffled from pocket lint, here is how we fix it.
Clear trapped water from your phone in about 60 seconds. The steady 165 Hz vibration physically pushes trapped liquid out of the speaker mesh.
A steady 165 Hz tone — the sweet spot for maximum diaphragm travel — physically pushes trapped water out.
Use our deep clean mode to act as a dust remover. Sweeping low frequencies shake loose stubborn dirt, sand, and lint.
Sweeps across low frequencies (120–400 Hz) to shake loose lint, dust and stubborn droplets the single tone misses.
Act as a volume booster for muffled speakers. Clear out blockages to restore heavy sound, loud bass, and crisp audio.
A clean 440 Hz reference tone so you can hear whether your speaker sounds clear again after cleaning.
Perfectly safe. These are ordinary frequencies your speaker already plays during music. The tool never exceeds normal listening levels — it just concentrates the energy at the frequency range where diaphragm travel is greatest.
Volume loss has a short list of causes, and working through them in order of likelihood finds most cases in a few minutes.
For a complete overview, see restoring lost volume and bass.
The commonest cause by a wide margin. A paired Bluetooth device in range takes the output silently. Turn the radio off in settings rather than just disconnecting.
Phones keep separate levels for media, ringer, calls and alarms. Pressing volume up outside an app usually adjusts the ringer. Start audio playing, then adjust.
A speaker restricted by water or lint produces genuinely less sound, because the diaphragm cannot travel its full distance. Sudden loss points at liquid; gradual loss over months points at dust. This is the case cleaning recovers.
Obvious once suggested and genuinely common, particularly with a newly fitted case.
Regional media caps, accessibility limits, parental or screen-time controls.
Bass boost and similar enhancements drive a small driver toward distortion, and distortion masks detail in a way frequently perceived as quieter. Flat often sounds louder.
After prolonged loud playback the voice coil heats, raising resistance and reducing output. Recovers as the device cools.
Last, because it is least likely for a sudden change with no drop or liquid involved.
If the loss was blockage, clearing restores full factory output — not more. Case off, brush the grille, Bluetooth off, volume 70–80 percent, grille facing down, three cycles. No software booster helps a restricted diaphragm; it produces distortion rather than volume.
Stop. If three cycles produce no improvement at all, the cause is not blockage. Check the symptoms on our guide to when a sound tool will not help, and have the device inspected rather than continuing to run cycles.
No. The frequencies used sit inside the range your speaker already reproduces whenever you play music, and the tool runs at moderate volume rather than maximum. The one genuine caution is earbuds: never run ejection tones into in-ear devices while you are wearing them.
Thirty to sixty seconds per cycle, repeated two or three times with short pauses. Running it continuously for many minutes adds nothing once the accessible liquid is out, and only heats the voice coil.
No. Around 70 to 80 percent is the practical sweet spot. Maximum volume on a restricted diaphragm produces distortion rather than more displacement, and adds avoidable stress to the driver.
No. Rice is a poor desiccant — open moving air dries a device faster — and its starch dust migrates into the charging port, microphone holes and speaker grille, which can create a second problem on top of the first.
Our tool is great for water and dust, but it cannot fix physically blown speakers or electrical damage.
Learn when it won't workStep-by-step help for wet, muffled, crackling or quiet phone speakers.